P2685Actuator Supply Voltage C Circuit Low
Hur akut är det?
Boka snarast
Bilen kan gå i nödläge med begränsad effekt. Kör lugnt och kort sträcka, helst direkt till verkstaden.
Vad koden betyder
Texten från felkodsdatabasen är på engelska tills vår svenska översättning är klar. Bedömningen av hur akut felet är har vi skrivit på svenska.
P2685 means the third actuator supply rail sags while it is switched on, almost always because the line or one of the loads it feeds has a path to ground. Unlike the open and switch faults of this rail, GM's 2023 and 2024 TCM tables check this one continuously during operation: if the voltage at high-side output 7 falls below a share of the supply, or the averaged output current runs too high, a timer counts up and the fault is confirmed after 60 ms. Battery voltage must lie between 8.75 and 18 V, the engine must not be cranking, and the test is suspended when P0882 or P0883 is present; GM rates it Type A. Ford's 2024 summary lists P2685 as the shorted-load fault of high side driver 7 in the TR9070 dual-clutch unit. The protected output switches off and the transmission falls back to a failsafe mode.
Så läser du koden
- P
- Drivlina – motor, växellåda och avgasrening
- 2
- Generisk kod: betyder samma sak i alla bilar
- 685
- Undersystem: styrenhet och utgångar, och felets nummer inom det
Troliga orsaker
- 1
Supply wire chafed through and touching ground
Vanligast
- 2
Shorted solenoid coil on this rail drawing excess current
Vanlig
- 3
Weak battery or charging fault pulling the whole supply down
Mindre vanlig
Vanliga symptom
- MIL on during the same trip
- Failsafe gear, no normal shifting
- Blown fuse possible on the transmission supply
Hur akut är det?
Boka snarast
Bilen kan gå i nödläge med begränsad effekt. Kör lugnt och kort sträcka, helst direkt till verkstaden.
Lyser en röd varningslampa, eller märker du rök, brandlukt, kraftiga ljud eller att bromsarna eller styrningen känns annorlunda: stanna så snart det är säkert och kontakta oss.
Åtgärden: Större arbete: kräver felsökning och ofta demontering.