P2420EVAP System Switching Valve Control Circuit High
Hur akut är det?
Boka inom några dagar
Motorlampan tänds. Bilen går oftast att köra, men boka inom några dagar så att felet inte förvärras.
Vad koden betyder
Texten från felkodsdatabasen är på engelska tills vår svenska översättning är klar. Bedömningen av hur akut felet är har vi skrivit på svenska.
P2420 means the control circuit of the EVAP switching valve reads high - typically a short to battery voltage on the control line or an overcurrent detected by the driver stage. Karma lists P2420 for the rear fuel tank isolation valve of the Revero and GS-6, which the ECM operates, and Subaru's bulletin 09-103-23 for 2015 Legacy/Outback with an evaporative leak check module (ELCM) includes P2420 among the codes to check alongside the pump fault P2404. Ford instead reports all circuit faults of its switching valve as P2418. CARB requires output components to be monitored for circuit faults. P2419 is the low-side fault and P2418 the open circuit. The evap leak monitor cannot run until the circuit is repaired.
Så läser du koden
- P
- Drivlina – motor, växellåda och avgasrening
- 2
- Generisk kod: betyder samma sak i alla bilar
- 420
- Undersystem: extra avgasrening, och felets nummer inom det
Troliga orsaker
- 1
Control wire shorted to battery voltage
Vanligast
- 2
Switching valve coil with too low resistance (overcurrent)
Vanlig
- 3
Faulty driver stage in the ECM
Mindre vanlig
Vanliga symptom
- Check engine light
- EVAP readiness not set
- No noticeable driveability change
Hur akut är det?
Boka inom några dagar
Motorlampan tänds. Bilen går oftast att köra, men boka inom några dagar så att felet inte förvärras.
Lyser en röd varningslampa, eller märker du rök, brandlukt, kraftiga ljud eller att bromsarna eller styrningen känns annorlunda: stanna så snart det är säkert och kontakta oss.
Åtgärden: Kräver felsökning med diagnosutrustning.